Extends the range of up to 500 m
Perfect for the installation of IP cameras
A master adapter supports the connection of up to four slave adapters
Compact design
Powered by C4 Line
PoE function: transmits even current for PoE-enabled devices
In principle, the range of an Ethernet network 100 m, which also the maximum length of the network cable is limited. Now, you may need to install, for example, a camera at greater distances.
With this network extension is the range up to 300 meters extended and speeds of up to 100 MBit/s is achieved. Perfectly suitable for low-cost IP-camera installations. Via a splitter, you can connect up to four slave adapter and your cameras. Of course, this technology is open for all protocols, codes and applications to the compatibility for IP cameras and associated management software.
In addition, the Extender Plug & Play-capable. For the installation is no IP address or network configuration is required.
Network signal and power forward in a
Through the PoE (Power over Ethernet) function can be used as a network, as well as current signal via 2-wire cable can be transferred. This is especially not available power connection in the vicinity of the receiver and the connected device helpful, since it despite its supply.
High compatibility
To the extent that they want to connect other devices to the network extension, you retain the re-purchase a complete system saves. Through a terminal strip splitter, you can simply add other receiver to the existing network and current signal connect, which in addition to the cost a lot of effort saves. The transmitter or receiver is equipped with all the CAT5, CAT5e, CAT6, CAT 6e and CAT 7 network cables as well as 2-wire cables compatible.
High transmission rate up to 200 Mbit/s
Small form factor for the installation even in confined spaces
A master extender supports several slave extender with terminal block splitter and the two lines bridge
Ethernet extension of up to 300 meters
Automatic Quality of Service (QoS) function for seamless network streaming
PoE-Standards: IEEE 802.3af/at at compatible PoE-enabled devices (PD), such as Wi-Fi Access Point, IP-Intercom System, IP-camera, VoiP-phone, etc.
Simple configuration and no IP address and network setup required
LED display for power, link and data traffic status
Standards: IEEE 802.3, IEEE 802.3u, IEEE 802.3x, Auto MDI/X
Protocols: TDMA & CSMA/CA
Transmission speed: 100 MBit/s Fast Ethernet
Modulation: OFDM -1024/256/ 64-QAM, QPSK, BPSK, ROBO
Frequency range: 1 - 30 MHz
Security: 128-bit AES-encryption
Power consumption: 2.5 Watt
Speed: 10/100 Base T, half-/full-duplex, auto-negotiation
PoE standard: IEEE 802.3af/at PoE+ 40 Watt
Impedance: 25 Ω ~ 100 Ω
Supported cable standards: 2-wire, Cat5, CAT5E, Cat6, CAT 6A, Cat 7
Material: Extruded Alumimun
02050005725000, 02050005724997, Renkforce, RF-3684876, ethernet expansion, ethernet extension
