Description
Important information
Shipping only within Europe
ORATEX ® heat-activated adhesive
As adhesive improver and heat-activated adhesive for ORATEX ®.
Not suitable for surfaces that are not resistant to organic solvents. Before the iron-dry thoroughly. Depending on the surface 1-2 times thin coat. Optimal consumption dry: 20 g/m2.
For each application area there are from us the appropriate adhesive. To wood surfaces especially "bracket friendly", the liquid glue of our house. They penetrate into the wood and glue unstable fibers of the surface with the surface. This prevents these fibers with stress and thus the film severed triggers, which usually the cause of wrinkles. Since the have broken fibers with the adhesive layer of the foil glued together, the adhesive is blocked, also again after ironing solves the problem not really, because the film although shrinks, but by the glue on the surface no longer have broken fibers blocked properly can become attached.
The liquid glue are with the corresponding adhesives of the respective films are identical. Therefore, it is always the adhesive is used, the film. The adhesive consumption is at approx. 20 g/m² with respect to the dry substance. It is important that the adhesive before the cover had dried completely, in order to prevent the incomplete evaporated solvent residues in bebugeln evaporation and bubbles may form. Should our glue in reuse of boxes, the adhesive with something drying the corresponding dilution back to brush viscosity can be set.
