PCE Instruments PCE-EVSE 300 Adapter 1 pc(s)

Overview

CP and PP simulationCarrying case included in deliveryDirect connection for wallboxesAdapter with type 1 and type 2 charging plugProtective conductor testIntegrated earthing contact socket

Description

EVSE adapter for charging plugs type 1 and 2, PP and CP simulation, Schuko socket connection, direct acceptance of all connections via laboratory plugs, electromobility plays an increasingly important role. An important point is the charging stations of electric vehicles. To check the fixed charging stations, also called wallboxes, special measuring instruments are required to check the function, the protective devices and the insulation. Often, there are already measuring devices in place to carry out the necessary measurements. An adapter is therefore required to connect the measuring device to the charging station. The EVSE adapter / test adapter for charging stations is specially designed for this application and already offers a variety of functions. Thus, all lines that go off the charging station are output individually via laboratory plugs. Thus, all cables can be tapped via the EVSE adapter. This allows the charging station to be checked for insulation using the EVSE adapter. The EVSE adapter has a safety plug connection. With the help of RCD tester, the residual current protection device can be checked in a charging cable not only the supply cables are present, in order to charge an electric vehicle, but also two interfaces. The electronic vehicle communicates with the charging station via the CP line (Control Pilot) and informs about the current status of the electric vehicle. The PP cable (Proximity Plug) is used for communication between the connected charging cable and the charging station / charging column. The charging cable can thus tell the charging station with how much ampere it may be charged. In order to test both functions, the EVSE adapter is equipped with corresponding simulators.

Characteristics

FunctionsPE test (protective conductor): Present, errorPP simulation (charging cable coding): Open, 13 A, 20 A, 32 A, 63 A.CP simulation (communication line): A, B, C, D, errorOutputs (for test purposes only) MEASURING CONNECTIONS: L1, L2, L3, N, PE MAX. 250 / 430 V AC, 10 A Jack PlugsEarthing contact: Max. 250 V AC, 10 AFuse from safety connection: Safety fuse F 10 A / 250 V, 5 x 20 mmCP SIGNAL OUTPUT: ± 12 V PWM Other specificationsInput voltage: 1 phase 250 V AC,3 phase 430 V AC,50 / 60 Hz, max. 10 A Charging cable plug type 1AC charging mode 3, compatible with IEC62196-1Type-1 or SAE J1772 with vehicle connection(Type 1, 5 pin, 1-phase) Charging cable plug type 2AC charging mode 3, compatible with IEC62196-2Type-1 or SAE J1772 with vehicle connection(Type 2, 7 pin, 3-phase)

Delivery content

• 1x PCE-EVSE 300 EVSE adapter for charging columns 1x charging cable plug type 1 1x charging cable plug type 2 1x carrying case 1x user manual

Keywords

PCE Instruments, PCE-EVSE 300, meter accessories, meter replacement, meter spare part, meter replacement part