Gossen Metrawatt M513R PROFITEST EMOBILITY 1 pc(s)

Overview

Testing of 1- and 3-phase E-charging cables Mode 2 and 3
Function and tripping test by simulation of the following fault cases: Interruption, conductor replacement and PE at phase
Measurement of the protective conductor current with clamp current transformer as accessory
Measurement of protective conductor and insulation resistance according to DIN VDE 0701-0702 with PROFITEST MXTRA / MTECH+
Trip test with nominal residual current and measurement of the trip time with PROFITEST MXTRA / MTECH+
Evaluation and logging of the individual test steps with PROFITEST MXTRA / MTECH+

Description

Adapter for standard-compliant testing of 1- and 3-phase charging cables Mode 2 and 3 by simulation of failure cases according to DIN VDE 0701-0702 and manufacturer's specifications.
The PROFITEST E-Mobility is an adapter for standard-compliant testing of 1- and 3-phase charging cables Mode 2 and 3 by simulation of failure cases according to DIN VDE 0701-0702 and manufacturer's specifications.
The PROFITEST E-Mobility makes the investment decision easy for you, because 1- and 3-phase charging cables Mode 2 and 3 can be tested quickly and safely according to DIN VDE 0701-0702 as well as the manufacturer's specifications in accordance with the standard with the accessories perfectly tailored to the requirements.

Characteristics

Testing of E-charging cables according to DIN VDE 0701-0702 as well as manufacturer's specifications through a guided test sequence with a recommended test device
Testing of charging cables of types Mode 2 and Mode 3
Testing of connecting cables with country-specific charging plugs (plug type 1 etc.)
Function or tripping test through simulation of the following fault cases: Interruption, Conductor replacement and PE on phase
Measurement of protective conductor current with clamp current transformer as accessory
Measurement of protective conductor and insulation resistance to DIN VDE 0701-0702 with a recommended tester
tripping test with rated residual current and measurement of the tripping time with a recommended tester
evaluation and logging of the individual test steps with a recommended tester
simulation of the vehicle condition according to EN 61851-1/VDE 0122-1
testing of the resistance coding for vehicle coupling and plug according to EN 61851-1/VDE 0122-1

applications:
Testing the effectiveness of protective measures on E-charging cables for electric and hybrid vehicles

Technical features:
The test adapter can be used to simulate the following faults in the mains supply of a charging cable (also without additional test device):
Replaced cores
Failure of individual conductors (undervoltage detection)
Axternal voltage on the protective conductor by connecting the phase to the protective conductor (switch position PE-UEXT)
The reaction of the charging cable to the respective fault is assessed purely optically:
ICCB active or inactive (signal lamp on ICCB)
Signalling of fault cases by LEDs on the test adapter

The following additional tests are possible if a recommended test device is connected to the test adapter:
Single measurements
Measure the protective conductor resistance of the charging cable using the RPE function on the test set
Measure the insulation

Delivery content

• 1 Test adapter in case
• 1 Mains connection cable
• 1 Operating instructions

Keywords

04053199581061, 04012932130669, Gossen Metrawatt, M513R, PROFITEST EMOBILITY, meter accessories