Do you want to add a WiFi interface to your devices? Get the MKR WIFI 1010! It connects easily with other Arduino products and is configurable with Arduino software - and you don't have to be a network expert. This is the latest version of the MKR 1000 WIFI, but with a ESP32 module of U-BLOX on board.
The MKR WIFI 1010 is a significant improvement over the MKR 1000 WIFI. It is equipped with a ESP32 module from U-BLOX. This board aims to accelerate and simplify prototyping of WiFi-based IoT applications thanks to the flexibility of the ESP32 module and its low power consumption.
SAMD21 Cortex-M0+ 32bit Low power ARM MCU Low power
on-board power supply (USB/VIN) 5V
supported battery(*) Li-Po single cell, 3.7V, 700mAh minimum
circuit operating voltage 3.3V
Digital I/O pins 8
PWM pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 - or 19)
UART 1
SPI 1
I2C 1
I2S 1
connectivity WiFi
analogue input pins 7 (ADC 8/10/12 bit)
analogue output pins 1 (DAC 10 bit)
external interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)
Direct current per I/O Pin 7 mA
Flash memory 256 KB
SRAM 32 KB
EEPROM No
clock frequency 32.768 kHz (RTC), 48 MHz
LED_BUILTIN 6
full-speed USB device and integrated host including
LED_BUILTIN 6
length 61.5 mm
width 25 mm
weight 32 g.
07630049200258, Arduino, ABX00023, MKR WIFI 1010, raspberry pi
