Numerous Current Analysis Functions Bright LED work light
The FLIR CM82 is an industrial grade current clamp with extensive current analysis functions and filtering for inverter-controlled drives as required in electrical troubleshooting. VFD mode for higher accuracy when working on inverter-controlled drives Extensive measurements of current efficiency and harmonic content for system level power analysis The powerful working light not only helps in measuring, it is also bright enough to be used as main working light.
In VFD mode, the variable signal frequency is processed by filters to measure the exact frequency and voltage values. This is important for service and maintenance work - Analog bargraph display of measured values - Power and power factor measurement - True RMS measurements of alternating voltages and alternating voltages with a direct component - Large, easy to read display - an additional illumination by a bright white LED in the display ensures good reading even in dark rooms - automatic AC/DC recognition even at a maximum current of 600 A - automatic AC/DC recognition even at a maximum voltage of 1000 V - automatic resistance, continuity and diode test recognition - measurement of the harmonic content / distortion up to the 25th harmonic distortion - automatic AC/DC recognition even at a maximum current of 600 A - automatic AC/DC recognition even at a maximum voltage of 1000 V - automatic resistance, continuity and diode test recognition - measurement of the harmonic content / distortion up to the 25th harmonic distortion The following functions are available: - Phase rotation indication - Resistance measurement up to 100 kΩ - Frequency measurement - Capacitance measurement - Holding the last measurement - Peak value measurement and storage - Measurement of inrush currents - Zeroing for DC currents - Storage of maximum, minimum and average values - VFD mode - Low-pass filter - Detector for detection and display when there is no contact - Automatic switch-off of the instrument when not in use - Gripper opening: 37 mm for 31 mm cable - Can withstand 1.2 m drop height - Safety category: CAT IV-600V, CAT III-1000V - Overvoltage category: IEC 61010-1 CAT IV-600 V, CAT III-1000 V, IEC 61010-2-033 - Specified temperature range 18 °C to 28 °C with specified accuracy: 0.2 * (accuracy)/°C - (H × W × L): 49 mm × 100 mm × 262 mm;Weight 590 g with batteries
6 pcs. AAA Batteries + User Manual/CD + CATIV Silicone Test Lead + Limited Lifetime Warranty
793950370827, FLIR, CM82, Clip-on ammeter, current pliers