Are you looking for a board for a specific purpose that Arduino has not yet offered? Or perhaps you want a more complex central board that is optimized for your specific needs and compatible with all other Arduino boards and devices. The MKR VIDOR 4000 is highly configurable and powerful and can perform digital audio and video processing at high speed.
With the MKR VIDOR 4000 you can configure a board according to your wishes; you can essentially create your own controller board. It is equipped with hardware and potential: An 8 MB SRAM; a 2 MB QSPI flash chip - 1 MB for user applications; a micro HDMI connection; a MIPI camera plug; and WiFi & BLE powered by U-BLOX NINA W10 series. It also includes the classic MKR interface, on which all pins are controlled by both SAMD21 and FPGA. It also has a mini PCI Express connector with up to 25 freely programmable pins. The FPGA contains 16K logic elements, 504 KB embedded RAM and 56 18x18 bit HW multipliers for high-speed DSP. Each pin can be toggling at over 150 MHz and configured for functions such as UARTs, (Q)SPI, high-resolution/high-frequency PWM, quadrature encoder, I2C, I2S, Sigma Delta DAC, etc. The on-board FPGA can also be used for high-speed DSP operations for audio and video processing. This board also contains a Microchip SAMD21. The communication between FPGA and SAMD21 runs smoothly.
FPGA Intel Cyclone 10CL016
Mini PCI Express Port with Programmable Pins
Camera Plug MIPI Camera Plug
Circuit Operating Voltage 3.3V
Digital I/O Pins 22 Headers + 25 Mini PCI Express
PWM Pins All Pins
UART up to 7 (depending on FPGA configuration)
SPI up to 7 (depending on FPGA configuration)
I2C up to 7 (depending on FPGA configuration)
Analogue input pins n/a
analogue output pins n/a
external interrupts N/A.
DC current per I/O Pin 4 or 8 mA
Flash memory 2 MB
SDRAM 8 MB
EEPROM n/a
clock frequency 48 MHz - up to 200 MHz
Video output Micro HDMI
microcontroller Microchip ATSAMD21 (Arm Cortex-M0+ processor)
Wi-Fi U-Blox Nina-W102
(VIN) 5V
supported battery(*) Li-Po single cell, 3.7V, 700mAh Minimum
operating voltage of circuit 3.3V
Digital I/O pins 22
PWM pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 - or 19)
UART 1
SPI 1
I2C 1
analogue input pins 7 (ADC 8/10/12 bit)
analogue output pins 1 (DAC 10 bit)
external interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 or 16, A2 or 17)
Flash memory 256 KB
SRAM 32 KB
EEPROM No
clock frequency 32.768 kHz (RTC), 48 MHz
LED_BUILTIN 6
Full-Speed USB device and integrated host including
LED_BUILTIN 6
length 83 mm
width 25 mm
weight 32 g.
Arduino, ABX00022, MKR VIDOR 4000, raspberry pi, raspberry
